Pasco PS-2111 EKG Sensor User Manual

Browse online or download User Manual for Equipment Pasco PS-2111 EKG Sensor. PASCO PS-2111 EKG Sensor User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
®
Instruction Sheet
0102-08007F
EKG Sensor
PS-2111
*012-088007
Included Parts
1. EKG Sensor
2. Electrode patches, 100 pieces
Additional Part Required
PASPORT interface or datalogger
Quick Start
1. Connect the EKG Sensor to your PASPORT interface.
2. If you are using a computer, connect the PASPORT interface
to it and start DataStudio.
3. Apply three electrode patches to the subject’s arms and clip
the leads to the electrodes patches as illustrated in Figure 1.
4. Press or click the start button to begin recording data.
Introduction
The EKG Sensor measures electrical signals produced by the
heart. The EKG trace, displayed on a connected computer or dat-
alogger, graphically illustrates the beating of the heart.
Set-up
Connecting the EKG Sensor to an Interface
1. Connect the sensor’s plug to any port of a PASPORT inter-
face or datalogger. Optionally, use a PASPORT extension
cable (PS-2500) between the interface and the EKG Sensor.
2. If you are using a computer, connect the PASPORT interface
to it and start DataStudio.
Connecting the EKG Sensor to a Person
1. Rub the skin where the electrode
patches will be applied with a
paper towel to remove dead skin
and oil.
2. Apply adhesive electrode
patches to the right wrist, right
forearm just below the elbow,
and left forearm just below the
elbow (Figure 1). Press the
patches firmly for best adhesion
and signal quality.
3. Clip the EKG leads to the elec-
trode patches: black to the right
wrist, green to the right forearm, and red to the left forearm.
4. Arrange the leads so that they hang loosely without straining
the patches.
Collecting Data
1. Press or click the start button to begin recording data.
2. Have subject remain still during data collection.
About the Measurements
The sensor makes two measurements: Heart Rate (in beats per
minute) and Voltage (in mV). These measurements are recorded
and displayed by the computer or datalogger connected to the
sensor.
1
2
right
red
left
green
black
Figure 1
Page view 0
1 2

Summary of Contents

Page 1 - EKG Sensor

®Instruction Sheet0102-08007FEKG SensorPS-2111*012-088007Included Parts1. EKG Sensor2. Electrode patches, 100 piecesAdditional Part Required• PASPORT

Page 2 - Technical Support

®EKG Sensor PS-21112Heart rate and voltage measurements are acquired at the default rate of 200 samples per second. You can lower the sample rate to 5

Comments to this Manuals

No comments